Filter
Top Products
CN 2110 Temperature Controller
CN 2110
13
Section 4–Adjusting Set Point and Configuration
Load
Alarm
¡F
¡C
Temp
Set
Point
Set Point
Chromalox
¤
2110
Load
Alarm
¡F
¡C
Temp
Set
Point
Set Point
Chromalox
¤
2110
Load
Alarm
°F
°C
Tem p
Set
Point
Set Point
Chromalox
®
2110
Figure 4.3
Figure 4.5
Figure 4.6
Figure 4.4
Figure 4.7
4. Press the or buttons to adjust the value (only the value is dis-
played during adjustment). See Figure 4.7. The new value is set when
the
or button is released.
5. Press and hold the Set Point (
) button and press the button to
advance to the next menu. See Figure 4.8. (Holding the Set Point
( ) button and pressing the button moves through menus in the
opposite direction.)
Repeat steps 4 and 5 through the configuration menus.
Exit Configuration
To exit configuration mode, press and hold both the
and buttons for
three seconds to return to the operation mode.
Note: If no buttons are pressed for three minutes while in user configu-
ration mode, then the controller will exit user configuration and return to
the operation mode.
Load
Alarm
¡F
¡C
Tem p
Set
Point
Set Point
Chromalox
¤
2110
Figure 4.8
Load
Alarm
¡F
¡C
Tem p
Set
Point
Set Point
Chromalox
¤
2110
Load
Alarm
¡F
¡C
Tem p
Set
Point
Set Point
Chromalox
¤
2110
Configuration
continued
Adjust lock
to 458
Move to
next menu
Continue
until SP is
displayed
Adjust the
set point
value
Continue
through the
configuration
menus