Filter
Top Products
Unied Access Point Administrator’s Guide
Unied Access Point Administrator’s Guide
Page 113
March 2012
Appendix A - Default AP Settings
Appendix A - Default AP Settings
When you rst power on a UAP, it has the default settings shown in the following table.
Feature Default
System Information
User Name admin
Password admin
Ethernet Interface Settings
Connection Type DHCP
DHCP Enabled
IP Address 10.90.90.91 (if no DHCP server is available)
Subnet Mask 255.0.0.0
DNS Name None
Management VLAN ID 1
Untagged VLAN ID 1
IPv6 Admin Mode Enabled
IPv6 Auto Cong Admin Mode Enabled
Radio Settings
Radio (1 and 2) One
Radio 1 IEEE 802.11 Mode 802.11a/n
Radio 2 IEEE 802.11 Mode 802.11b/g/n
802.11a/n Channel Auto
802.11b/g/n Channel Auto
Radio 1 Channel Bandwidth 40 MHz
Radio 2 Channel Bandwidth 20 MHz
Primary Channel Lower
Short Guard Interval Supported Yes
STBC Mode On
Protection Auto
Maximum Wireless Clients 200
Transmit Power 100 percent
Legacy Rate Sets Supported (Mbps) IEEE 802.11a: 54, 48, 36, 24, 18, 12, 9, 6
IEEE 802.11b: 11, 5.5, 2, 1
IEEE 802.11g: 54, 48, 36, 24, 18, 12, 11, 9, 6, 5.5, 2, 1
Legacy Rate Sets (Mbps)
(Basic/Advertised)
IEEE 802.11a: 24, 12, 6
IEEE 802.11b: 2, 1
IEEE 802.11g: 11, 5.5, 2, 1
MCS (Data Rate) Settings
(802.11n only)
0–15 Enabled
Broadcast/Multicast Rate Limiting Disabled
Fixed Multicast Rate Auto
Beacon Interval 100
DTIM Period 2
Fragmentation Threshold 2346
RTS Threshold 2347
TSPEC Mode Off
TSPEC Voice ACM Mode Off
Virtual Access Point Settings
Status VAP0 is enabled on both radios, all other VAPs disabled