Filter
Top Products
151
To access the Set Local Time menu, acquire your position, then press
MENU|MENU|↓ to SYSTEM SETUP|ENT|↓ to SET LOCAL TIME|ENT.
To set Local Time:
Press ENT. Press ↑ ↓ to change the first character,
then press
→ to move the cursor to the next character. Repeat until the
time is correct and press
ENT.
To set the Day: Press → to DAY|ENT. Use ↑ ↓ to select the day and
press
ENT.
To set the Month: Press ↓ and ← to MONTH|ENT. Use ↑ ↓ to select the
month and press
ENT.
To set the Year: Press → to YEAR|ENT. Press ↑ ↓ to select the year and
press
ENT.
To set Time Format: Press ↓ to TIME FORMAT|ENT. Use ↑ ↓ to select the
desired Time Format and press
ENT.
To set Date Format: Press ↓ to
DATE FORMAT|ENT. Use ↑ ↓ to select the
desired Date Format and press
ENT.
In the center of the local time menu is CONFIG DST. It allows your unit to
automatically make the adjustment for Daylight Savings. You may se-
lect which set of rules matches DST in your region or accept the de-
fault. Once you are satisfied with the time settings, press
EXIT repeat-
edly to get back to the main page display.
Show WAAS Alarm
When the signal is available, your unit will automatically use WAAS to
boost the accuracy of a position fix. When the WAAS signal is lost or
acquired, an alarm message appears. Since the U.S. government is still
developing the WAAS system, it is not unusual for a GPS/WAAS re-
ceiver to frequently lose and reacquire its lock on a WAAS satellite.
That can result in the alarm going off repeatedly. If you want, you can
turn off the WAAS Acquired/Lost alarm without affecting how the unit
uses WAAS.