Filter
Top Products
DANIEL™ SERIES 1500 TURBINE METER OCT 2013
INSTALLATION 3-3
When installing this equipment, bolting must conform to the requirements of ASME B16.5
paragraph 5.3 and to the material requirements of ASME B16.5 Table 1B. Gaskets must conform
to the requirements of ASME B16.20.
It is the customer's responsibility to ensure that piping or other attachments connected to the Product
do not place adverse stresses on the Product.
The design of the Product has not been assessed for the effects of traffic, wind or earthquake
loading.
It is the customer's responsibility to provide fire prevention measures and equipment per local
regulations.
PERSONAL INJURY AND/OR DEATH
Never use equipment for unintended purposes.
Use of this equipment for any purpose other than its intended purpose may result in property
damage and/or serious personal injury or death.
The Product has been designed with a minimum of 1.5mm (.059 inches) corrosion allowance. The
customer should implement a periodic inspection and maintenance program to ensure that no part
of the Product's pressure-retaining components has corrosion or erosion exceeding this amount. (The
design engineer may choose to select a different corrosion allowance, but it should be identified and
published.)