Filter
Top Products
1. INSTALLATION
1-15
75 mm(3")
minimum beyond
swing radius
Mounting location on single drive boat
Note 4: For twin drive boat, mount between the drives.
Installation of bracket
1. Cut out the installation template shown on the left.
2. At the selected location, position the template, so the arrow at the bottom is aligned with
the bottom edge of the transom. Being sure the template is parallel to the waterline, tape
it in place.
Installation template
for starboard side of boat
Drill at locations labeled "B"
for the following transom angles:
16
°
through 22
°
Drill at locations labeled "A"
for the following transom angles:
2
°
through 15
°
Align arrow with bottom of transom
AAA
BBB
Warning: Always wear safety goggles and a dust mask.
Align template vertically.
Deadrise angle
Slope of hull
parallel to
waterline
Align template arrow with
bottom edge of transom.
Positioning the template