Filter
Top Products
4. INCORPORATION OF DGPS BEACON RECEIVER KIT (for GP-1850WF)
4-7
Note: When reattaching the cover, confirm the following parts are attached.
•
Inside of the cover : Shield gaskets, GN gasket (See the figure below.)
•
On ANLG Board : Connector gasket (See the page 4-2.)
GN gasket
Shield gaskets
Inside of the cover
Checking the beacon receiver
1. Press the [MENU] key.
2. Press the CONFIGURATION soft key.
3. Press the SYSTEM MENU soft key.
4. Press the SELF TEST soft key.
5. Press the MEMORY•I/O TEST soft key to display the following message.
PRPGRAM:OK
NO.1418270XX
RETURN
TEST
SRAM:OK
DRAM:OK
PORT1:OK*
PORT2:OK*
INTERNAL
BATTERY: OK
GPS
RECEIVER:OK
NO.48502370XX
BEACON
RECEIVER:OK
NO.08501820XX
NO.
*:Special connections are required to check these port.
Otherwise, "--"(bar) appears.
Memory, I/O Test Display
6. Confirm that BEACON RECEIVER: OK is displayed.
7. Press the RETURN soft key.
8. Press the [PLOT] key to return the plotter display.