Filter
Top Products
2. WIRING
2-13
Fabricating of MPYCY-19
1. Fabricate the cable as below.
30
5
Armor
Vinyl sheath
Approx. 250
Vinyl sheath
6
Unit: mm
2. For not used cores, wind the vinyl tape around them to prevent the short circuit.
Wiring
1. Remove the cover from the RTR-081A.
2. Pass the cables through the cable entrance of the RTR-081A, and then fix the armors
with the cable clamp.
TB801
TB803
TB804
TB802
Do not remove this film.
TB Board
Cable entrance
Transceiver unit RTR-081A, internal view
3. Connect each cores to TB801, TB802, TB803 and TB804 referring to the
interconnection diagram.
4. Connect the grounding wire (shipyard supply) between the ground terminal (behind of
the cable clamp) and the grounding point.