Filter
Top Products
2. WIRING
2-20
3. Taking care not to scratch the outer conductor, remove the jacket: Cut the jacket
circularly first with a tubing cutter, cut in a straight line with a knife, then remove the
jacket with a cutting pliers.
Remove burrs.
24.5 to 25 mm
4. Clean the outer conductor with a gasoline and cloth.
5. Heat the cutting off tool (or hacksaw and cutter) with the burner. Then, remove with the
cutting off tool the insulator between the inner and outer conductors by the depth of 6
mm.
Outer conductors
Insulator
6
6. Clean the outer and inner conductor with gasoline and cloth. Slip the clamping nut,
spacer, gasket and outer clamp on the cable in that order. (Parts No. 1, 2 and 3 in the
figure shown in page 2-19)
Assembled with (1), (2) and (3)
Clamping nut
Coaxial cable