Filter
Top Products
vii
FAR-2837SW
Processor Unit
RPU-013
Navigator
IEC-61162-1 Serial data
*
2
(Input/output)
IEC-61162-1 Serial data
(Input)
Speed Log
Gyro Compass
AIS
Switching HUB HUB-100
Track control unit
: Option
: Shipyard Supply
: Standard Supply
AD-100
Memory Card
Interface Unit
CU-200-FAR
VDR
External Monitor
Sub Display
Alarm
*
5
Control Unit
RCU-014
or
RCU-015
Remote Controller
RCU-016
Antenna Unit
Gyro Converter
GC-10
Performance
Monitor
RJB-001*
1
100-230 VAC
SN30AF/SN36AF
Transceiver Unit
RTR-082
RU-6522
RU-5693
RU-5466-1
Coaxial cable CX-20DF
or
Waveguide WRJ-3
RSB104
RSB105
RJB-001*
1
*
4
*
4
*
4
Category of Units
Antenna Unit: Exposed to weather
All other units: Protected from weather
*
1
When length of antenna cable is more than 100 m.
*
2
For IMO spec, IEC-61162-1 Edition 2 is required.
*
3
Russian flag vessels only.
*
4
Not available with HSC spec.
*
5
Contact output for Alarm
(Load current) 120 mA, (Polarity) No.1/2: Normally Close, No.3/4: Normally Open
Serial I/O for alarm is also possible, which complies with IEC 61162-1.
Step or synchro signal
IEC-61162-2
RU-3305
(For de-icer)
AC spec
Transformer Unit
RU-1803
Power Supply Unit*
3
PSU-011
1)
2)
3)
*
6
This monitor has been approved by the IMO (CAT 1). If a different monitor is to be used,
its effective diameter must meet the applicable Category requirements (effective diameter
320 mm or higher). Refer to its operator's manual for details.
Monitor Unit
MU-231CR
or
MU-231
*
6
1) Connect the EPFS which is approved in accordance with the requirements of the IMO in
resolution MSC.112(73) is used.
2) Connect the SDME which is approved in accordance with the requirements of the IMO
in resolution MSC.96(72) is used.
3) Use the gyrocompass having an update rate that is adequate for the ship’s rate of turn.