Filter
Top Products
10
4. BASIC OPERATION
General
This section provides information necessary for basic operation of
the CSH-5 MARK-2, from turning the power on and off to detecting
and tracking fish schools. The basic operating procedure is shown
below.
Basic Operating Procedure
2/7 Lower/raise transducer.
Location for
magnetic function
card
4 Turn transmitter on.
1/8 Turn power ON (OFF).
6 Adjust gain.
3 Select display range.
OUTPUT 10
PL 10
TVG, (Far, Near) 5, 5
AGC 0
NOISE LIM 3
VP 1
IR OFF
5 Set tilt angle.
CONTROL SETTINGS
Turning the Power On/Off
Power On
Press the POWER switch on the main panel. The lamp at the left of
the switch lights.
Note:
The Display and the Transceiver are checked for proper op-
eration each time the power is applied. The check is explained
in greater detail in a later chapter.