Filter
Top Products
14
DISABLE SOURCES — Use this option to turn on/off the AM and VHF sources.
For example this is useful if you only wish to listen to FM and do not wish to step
through AM and/or VHF when selecting a tuner source.
Note: USB/iPod/MTP Device/Bluetooth source only available if a device is
connected.
Accessory (Shared BT-200 Bluetooth & SiriusXM Source) — If you have installed
the MS-BT200 Bluetooth module or SiriusXM Tuner (USA Only) you will need
to enable the source. This operation will be determined by the Tuner region you
have selected.
Tuner Region - USA — When USA Tuner region is selected, press the menu
button and select Settings > Accessory then select the source to enable
SiriusXM or Bluetooth.
Tuner Region - Australasia-Europe-Japan — In these Tuner regions once the
MS-BT200 is installed and connected the source will be available.
SET DEVICE NAME — Select `Set Device Name’ to give the MS-RA205 a network
name of your choice. The name is visible to other devices (Marine Wired Remotes
MS-NRX200i) connected to the same FUSION network. Rotate the rotary encoder
to change the character. Press the rotary encoder to select. Press the `Previous’
button to delete characters.
· To save changes press the ‘Play’ key.
· To exit without saving any changes: press the Menu key.
UPDATE – MS-205 — This option is provided for future MS-RA205
software updates.
NRX-200: This option is provided for future software updates to remote controls
(MS-NRX200i) attached to your MS-RA205.
Note: FUSION recommends updating all remote(s) software via the MS-RA205 at time of
installation to ensure compatibility. This can be done via the Update menu. Please refer to your
remote manual for more information.
FACTORY RESET — The factory reset function will return all settings in the
MS-RA205 to the factory default value.
Warning: All AM, FM and VHF station presents are erased. Tuner and VHF tuner
regions are reset to USA. All zones are enabled and zone settings, tone, subwoofer
filter settings, source settings and device name are returned to default values.