Filter
Top Products
11
Attach the bridle wires to the bow tangs.
Mast Set-up
Lay the mast on top of the boat with the sail track to
the bottom and the mast base toward the bows.
Place padding under the mast to prevent scratching.
1
Lay the shroud wires and trapeze wires down each
side of the mast. Secure the trapeze wires temporarily
near the base of the mast.
2
Ensure that the shroud anchor pins are sealed, tight
and pointing at 90° to the centreline of the hull. Attach
the twist toggles to the anchor pins using the clevis
pins and rings. If you have the optional spinnaker kit
use the 6-mm bow shackles provided instead of the
clevis pins .
Attach the stay adjusters to the twist toggles with the
clevis pins and rings.
Attach both shrouds into the top hole of the respective
stay adjusters. This is only a temporary position for
3
raising the mast.
Now, attach the jib furler to the bridle wires.
NB
: Ensure that the hole in the furler housing is facing
towards the front crossbar. Now also is a good time to
roll some line onto the furler drum. Leave enough line
unfurled to reach the front crossbar mounted furler
cleat.
4
5