Filter
Top Products
4
Hull assembly
Position the hulls in parallel with the inner sides fa-
cing the ground.
Lift the right hull. One person straddles the hull to
hold it in place. The other person applies the silicone
sealant (for waterproofing) around the screw holes.
1
Take the front crossbar (with dolphin striker). Place it
in its support so that the trampoline track faces the
rear of the boat. Insert the two bolts. Pass your
hand through the inspection port to position the nuts
and washers onto the screws photo). Fasten loosely.
Lift the left hull, and follow the same steps as for the
right hull. Do not fully tighten the screws.
***Respect same order for the washers as
assem-
bled at the delivery***
2
Apply silicone sealant around the screw holes at the
back of the hulls. Place the rear crossbar on the right
side. Insert the bolts, washers and nuts as shown
for the front crossbar. Do the same thing for the left
side.
Once the frame has been mounted, tighten all the
bolts fully and then install the lock nuts.
3
I t is advisable to check the fastening of the bolts after the first trip out onto the water, and
recheck these at regular intervals.