Filter
Top Products
9
Mast Set-up
Place the mast onto two supports (eg: two
pieces of polystyrene).
Unroll the trapeze wires and fix them using a
shackle to the upper hole on the mast tang (two
on each side).
1
Unroll the shrouds and the forestay wire (with
the jib halyard block) and fix them to the lower
hole of the mast tang using a shackle. The
shrouds go onto each side of the forestay.
Trapeze wires
Trapeze wires
Shrouds
Forestay
2
IMPORTANT : Do not forget to attach the jib ha-
lyard rope to the small single block at the end of
the jib halyard wire. Tie off the jib halyard wire
and rope near the base of the mast.
3