Filter
Top Products
24
Self Test displays results from the internal diagnostic self test, including unit serial
number, Printed Circuit Board (PCB) serial number, software revision, total hours of
operation and the input voltage.
Accessory Test lists the accessories connected to the
system.
NOTE: The speed accessory will be detected only if the
paddlewheel has moved since your Matrix™ Fishing System
was powered up.
Exit System Status by powering your Matrix™ Fishing
System off.
PC Connect (With PC Connect Cable Only)
Use PC Connect to update the software of the Matrix™ control head. This feature requires
the use of the PC Connect Cable. Complete instructions are included with the PC Connect
Cable accessory.
NOTE: The PC Connect Cable requires a separate purchase. For more information visit our website at
www.humminbird.com or contact our Customer Resource Center at 1-800-633-1468.
Exit PC Connect mode by powering your Matrix™ Fishing System off.
System Status Accessory Test Screen
Simulator
Use the Simulator to learn how to use your Matrix™ Fishing System before taking your boat
on the water. The Simulator is a very powerful tool that simulates on the water operation,
providing a randomly-updated display. We recommend going through this manual while
using the Simulator, since all of the menus function and affect the display the way they
actually do when in Normal operation.
NOTE: To get the full benefit of the Simulator, it is important to select Simulator manually from the Start-
Up Options menu as opposed to letting your Matrix™ Fishing System enter Simulator automatically (as
it will if a transducer is not connected and you do nothing during power up). Manually selecting
Simulator from the Start-Up Options menu allows you to pre-configure your Matrix™ Fishing System for
on the water operation. Any menu changes you make will be saved for later use.
A message will appear on the display periodically to
remind you that you are using the Simulator.
Exit the Simulator by powering your Matrix™ Fishing
System off.
System Status
Use System Status to view system connections and to
conduct a unit self-test.
The following screens are displayed in turn when you
press the VIEW button when using System Status:
• Self Test
• Accessory Test.
System Status Self Test Screen
Simulator
23
M47_Man_Eng_531338-1_A.qxd 12/13/2004 12:35 PM Page 28