Filter
Top Products
40
Max Depth
(Advanced)
Max Depth adjusts the maximum depth of operation. The performance of your Matrix™
Fishing System can be tuned to the maximum depth you will be fishing in by setting the Max
Depth. When a maximum depth is set, your unit will not attempt to acquire sonar data
below that depth, thus increasing overall performance. When Max Depth is set to Auto, your
unit will acquire bottom readings as needed (within the depth capacity of the unit). If the
bottom is deeper than the Max Depth setting, the digital depth readout will flash, indicating
that your unit cannot locate the bottom. The Max Depth menu choice is available when User
Mode is set to Advanced (see Setup Menu Tab: User Mode).
T
o change the Max Depth setting:
1. Make sure you are in Advanced User Mode, then highlight Max Depth on the Sonar
main menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Max Depth setting.
(AUTO, 10 to 1000 feet, 3 to 330 meters [International Models Only], Default = AUTO)
Water Type
(Advanced)
Water Type configures your unit for operation in fresh or salt water. The Water Type menu
choice is available when User Mode is set to Advanced (see Setup Menu Tab: User Mode).
NOTE: In salt water, what would be considered a large fish might be 2 to 10 times bigger than a large
fish in fresh water (depending on the type of fish you are seeking). The salt water setting allows for a
greater range in fish size adjustment to account for this. Also, make sure that the Water Type is set
accurately, especially in salt water, as this affects the accuracy of deep water depth readings.
T
o change the Water Type setting:
1. Make sure you are in Advanced User Mode, then highlight Water Type on the Sonar
main menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Water Type setting.
(Fresh, Salt, Default = Fresh)
39
Surface Clutter
(Advanced)
Surface Clutter adjusts the filter that removes surface clutter noise caused by algae and
aeration. The lower the setting, the less surface clutter will be displayed. The Surface Clutter
menu choice is available when User Mode is set to Advanced (see Setup Menu Tab: User Mode).
T
o change the Sur
face Clutter setting:
1. Make sure you are in Advanced User Mode, then highlight Surface Clutter on the
Sonar main menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Surface Clutter
setting. (Low = 1 to High = 10, Default = 5)
Noise Filter
(Advanced)
Noise Filter adjusts the sonar noise filter to limit interference on the display from sources such
as your boat engine, turbulence, or other sonar devices. The Noise Filter menu choice is
available when User Mode is set to Advanced (see Setup Menu Tab: User Mode).
NOTE: The Off setting removes all filtering; Low, Medium and High settings add progressive filtering
of the sonar returns. In some deep water situations, the High setting may actually hinder your unit’s
ability to find the bottom.
To change the Noise Filter setting:
1. Make sure you are in Advanced User Mode, then highlight Noise Filter on the Sonar
main menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Noise Filter setting.
(Off, Low, Medium, High, Default = Low)
Surface
Clutter
M47_Man_Eng_531338-1_A.qxd 12/13/2004 12:36 PM Page 44