Filter
Top Products
AUXILIARY GEARING - “44” SERIES
(36164
AND 36165)
DISASSEMBLY
REASSEMBLY
a. Tap drive end of spindle with a soft face hammer to remove
from housing.
b. Remove bearing (36151) and spacer (36139).
c. Remove shafts (36137), releasing gears from spindle.
d. If it should become necessary to remove front bearing (36151)
and spacer (36138 or 36154-1); after removal of rear bearing
(36151) and spacer (36139), alternately tap ends of shafts
(36137) to remove front bearing and spacers,
a. Assemble spacers (36138 or 36154-1) and bearing (36151)
to spindle.
b. Assemble gears to spindle and secure with shafts to align
shafts to spacer.
c. Assemble spacer (36139) and bearing (36151) to rear of
spindle.
d. Assemble with retaining ring (36152-1) into housing.
36138 SPACER
36137 SHAFT (2)
36152-1 RETAINING
RING
36 I39 SPACER
36132 SPINDLE
3615 BEARING
FLAT SIDE OF SPACER
36151 BEARING
36164 GEARING ASS'Y
S 33517
GREASE FITTING
36159 GEAR (2)
36154-1 SPACER
36152-1 RETAINING RING
7
36145 SPINDLE
38309 HOUSING
INCLUDES 335
GREASE FITTING
-FLAT SIDE OF SPACER
36165 GEARING AS
(4:l)
FIGURE3
-5-