Filter
Top Products
PIPE PLUG Y227-3
PIPE PLUG (2) Y227-3
L
34497 HEAD
FIGURE 7
When assembling Head or Motor Section to models having
reversible rotation motor assemblies the following method
on head aligning Roll Pin that extends through end plate
of assembly is recommended.
with locating hole in head (center hole of 7 holes). Slip
Place Head (flats of head) in a suitable holding device with
motor housing (with manifold and “0” Ring attached) over
threaded end in an upright position. Place motor assembly
motor and secure to head. Assemble Spacers (33699),
(33711) and gearing to tool.
DIMENSIONAL DATA
MANIFOLD ADJUSTABLE 360”
“N” (4) MOUNTING HOLES