Filter
Top Products
33705 BEARING
ROLL PIN Yl76-23
34466 END PLATE
0 TORQUE TO 28 IN. LBS
33701 SPACER
33709 BEARING (FLUSH
FACE--INSTALL WITH FLUSH
FACE TOWARDS END PLATE)
33700 SEMS FASTENER 0
INCLUDED WITH 38301
X NOT INCLUDED WITH MOTOR
33705 BEARING
33711 SPACER *
33694 NUT
TORQUE TO 9- I2 FT LBS
38302-1
MOTOR ASS’Y
USED WITH MODELS 8273-( )A
0 TORQUE TO 28 IN. LBS
33701 SPACER
33709 BEARING (FLUSH
FACE--INSTALL WITH FLUSH
FACE TOWARDS END PLATE)
-- 33700 SEMS FASTENER
f INCLUDED WITH 344
* NOT INCLUDED WITH MOTOR ASS’Y.
41520 BLADES
+ ROLL PIN (2)
Yl7B-20
33705 BEARING
33701 SPACER
TORQUE TO
9- 12 FT LBS.
4 I523 MOTOR ASS’Y.
USED WITH MODELS 8274-c )A
33709 BEARING (FLUSH
FACE-INSTALL WITH FLUSH
FACE TOWARDS END PLATE)
S FASTENER 0
33699 SPACER
35679 CYLINDER
33710 END PLATE
f INCLUDED WITH 35673 CYLINDER
* NOT INCLUDED WITH MOTOR ASS’Y.
41522 MOTOR ASS’Y
0 TORQUE TO 28 IN. LBS
USED WITH MODELS 8276-l )A
MOTOR HOUSING & EXHAUST MANIFOLD
FIGURE:
43874-1 (SINGLE DIRECTION MODELS)
43551-3 (REVERSIBLE MODELS)
INCLUDES 35967 GREASE FITTING (NOT SHOWN)
42339 GASKET(2)
37891 HOUSING (BOLT-ON)*
Y325-129 “O”
RING
NOTE: it may be necessary to use one or more
Gaskets (42338) to prevent binding of motor
assembly when bolting motor housing
to gearing.
39655 MANIFOLD
POSITION MANIFOLD WITH MUFFLER APPROXIMATE-
LY 180° FROM EXHAUST SLOTS IN CYLINDER
------
FIGURE 6
DISASSEMBLY
REASSEMBLY
a.
To remove Manifold, remove head and “0” Ring a.
(Y325-129) and slip manifold off housing.
Assemble Manifold and “0” Ring (Y325-129)
to
hous-
ing.
NOTE: On models with bolt-on type gearing it may be
necessary to use one or more Gaskets (42338) to prevent bin-
ding of motor assembly when bolting motor housing to gear-
ing.
-7-