Filter
Top Products
SECTION 4—JOYSTICK DESCRIPTIONS
MK
5
™NX™Electronics 16 Part No 1110532
On/Off Button
This button is located at the front of the joystick housing. It is used to turn the wheelchair
on and off, to remove the joystick from sleep mode (if programmed) and to lock or unlock
the joystick (if programmed).
Speedometer
The speedometer is used to show the maximum speed. The right-most LED indicates
current maximum speed setting. The bottom left GREEN LED flashes to indicate that the
joystick is in speed limit mode. Speed limit mode limits the drive speed to a pre-
programmed value, typically when the seat has been elevated and the wheelchair is
required to drive at 20% speed.
Speed Control Buttons
The speed control buttons (tortoise button ( ) and hare button ( )) are used to set and
adjust the maximum speed.
1. To adjust the speed, perform one of the following:
• Adjust Speed in 20% Increments (5 Speed Mode) - Press the tortoise button ( )
or hare button ( ) to decrease/increase the speed in 20% increments. The larger
bars in the speedometer will light.
• Adjust Speed in Smaller Increments (VSP Mode) - Perform the following steps:
i. Press and hold both the tortoise button ( ) and hare button ( ) until the
joystick beeps.
ii. Perform one of the following:
• Press the tortoise button ( ) or hare button ( ) to decrease/increase the
speed in 20% increments. The larger bars in the speedometer will light.
• Press and hold the tortoise button ( ) or hare button ( ) to decrease/
increase the speed in smaller increments. The smaller bars in the
speedometer will light.
Mode Button
NOTE: The mode button is present on the SPJ+ w/ACC joystick only.
Press the mode button to switch from driving mode to elevate mode. Refer to the
wheelchair owner’s manual for elevating seat operating instructions.