Filter
Top Products
3
Introduction
This instrument is a high-accuracy spectroradiometer designed to measure luminance and
chromaticity up to super-low luminance regions. Carefully read this manual before using one.
Packaging material
Be sure to save all packaging materials (corrugated cardboard boxes, pads and plastic
bags) supplied with the purchase. This is delicate measurement instrument. Use packaging
materials supplied in purchasing in case this instrument needs to be transferred for such
purpose as maintenance in KONICA MINOLTA's factories. These packaging materials are
useful for minimizing shock or vibration to this instrument in such situation.
Should any of these packaging materials be lost or broken, please contact the nearest
KONICA MINOLTA authorized service facility.
Note on Use
Operating Environment
The standard AC adapter (AC-A312) of this instrument is designed specifically for use
indoors. Do not use it outdoors.
Do not disassemble this instrument for being composed of delicate electronic components.
Use this instrument at rated voltage of 100 V - 120 V
or 200 V - 240 V
(50/60Hz).
Connect AC power cord to AC outlet with rated voltage and frequency. Connected
voltage should not be outside the range of ±10% of nominal.
This instrument is classified into a Pollution Degree 2 as instrument used in mainly in
manufacturing plant, laboratory, warehouse or equivalents. Use this instrument in metal
dust free and non condensing potential environment.
This instrument is categorized into Installation Category II as equipment connected to
commercially available power source.
Connect PC for controlling this instrument to the outlet with protective grounding.
Failure to follow this may result in electric shock due to short circuit.
Take care not to enter foreign substance like water or metal in this instrument.
Operating in such state cause serious danger.
Do not use this instrument under direct sunlight or near heater. The internal temperature of this
instrument to becomes much higher than ambient temperature which may break this instrument.
Also, use this instrument in a well-ventilated place. To ensure proper heat dissipation,
keep the ventilation holes free from obstructions.
Avoid rapid change in ambient temperature which may form dew condensation.
Avoid using this instrument in extremely dusty or humid place.
Use the CS-2000 at ambient temperature between 5 and 35ºC and relative humidity
80% or less (at 35ºC) with no condensation. Use the CS-2000A at ambient
temperature between 5 and 30ºC and relative humidity 80% or less (at 30ºC) with no
condensation. Operating this instrument outside specified temperature and humidity
range may not satisfy its original performance.