Filter
Top Products
85
NOTE:
With Simulate Position checked, the simulator will also automati-
cally run the GPS simulator (if GPS data was recorded with the so-
nar log).
2. To use the default sonar chart log stored in the unit, press
ENT
|
EXIT
.
The recorded chart begins scrolling across the screen, just as if you
were on the water.
3. Turn off Sonar Simulator by pressing
MENU
|
MENU
|↓ to
S
ONAR
S
ETUP
|
ENT
|↓ to
S
ONAR
S
IMULATOR
|
ENT
|
ENT
|
EXIT
.
Sonar Page, playing a recorded sonar chart in Sonar Simulator mode.
Tip:
The Sonar Simulator can use sonar charts that you or a friend have
recorded (logged) on an MMC card. (To see how, read the entry in
this section on Log Sonar Chart Data.) To play back your own sonar
chart, make sure the MMC containing the chart is installed, then:
1. Press
MENU
|
MENU
|↓ to
S
ONAR
S
ETUP
|
ENT
|↓ to
S
ONAR
S
IMULATOR
|
ENT
.
2. Press ↓ to
C
HART
U
SED
|
ENT
.
3. Press ↓ or ↑ to select chart name|
ENT
|↑ to
S
ONAR
S
IMULATOR
O
N
|
ENT
|
EXIT
.
While you're in the Sonar Simulator menu, don't forget to check
Simulate Position if you want to run the sonar and GPS simulators
simultaneously. As you review sonar logs, you can create waypoints
to mark sites you want to return to.
While the simulator is running, you can switch from one chart log
to another by opening the Sonar Simulator menu and using the in-
structions in step 2 to select a different chart.
"Play"
symbol
flashing
Title bar with chart file name