Filter
Top Products
13
ii. Visually examine your PFD for damage or
excessive abrasion, wear, tear or contamination.
Particular attention must be paid to the
stitching. If in doubt, send it to your Mustang
dealer for evaluation and/or servicing.
iii. Replace the automatic inflator bobbin.
Re-assemble inflation system parts and repack PFD as
outlined in previous instructions and illustrations.
Warning: If you are not confident in the self inspection
and servicing of your Inflatable PFD, in accordance
with these instructions, take your Inflatable PFD to
a Mustang dealer for professional servicing or contact
Mustang Survival (see contact information on back
of manual).
MUSTANG ACCESSORIES
The MD2010 requires re-arm kit MA2010 and the
MD2012 requires rearm kit MA2012.
Cleaning and Storing of Your Inflatable PFD
(MD2010)
To clean your Inflatable PFD, remove the CO2 cylinder.
Hand wash or sponge down the Inflatable PFD in warm
water and rinse with clean water. Hang to dry on
a plastic coat hanger. Be sure to replace CO2 cylinder.
See Re-arming your PFD After Manual Inflation
(MD2010) (p. 7).
Always store your Inflatable PFD in a warm, dry place out
of direct sunlight.
Cleaning and Storing of Your Inflatable PFD
(MD2012)
To clean your Inflatable PFD, remove the CO2 cylinder,
auto-cap and bobbin. Keep the bobbin dry. Hand wash
or sponge down the Inflatable PFD in warm water.
Rinse the PFD and inflator with clean water. Hang the
Inflatable PFD to dry on a plastic coat hanger. Ensure the
inflator is thoroughly dry before installing the bobbin.