Filter
Top Products
3
3. If your inflator has a metallic lever attached to
the pull tab, make sure the lever is in the up-and-
ready position and insert the green indicator pin
if not already in place. Make sure the CO2 cylinder
is screwed hand tight into the inflator (Fig. 2 for
the MD2010)
4. If your inflator has a red lever attached to the pull
tab, make sure the red lever is retracted and insert
the green indicator clip over the red lever if not
already in place. Make sure the CO2 cylinder is
screwed hand tight into the inflator (Fig. 6 for
the MD2012).
Pierced OK
Dust Cap
in stowed
position
Dust Cap
in deflation
position
Green Indicator
Red Spring
Cap In Deflate
Position
Cap In Deflation
Position
Cap In Inflation
Position
Piercing PIn
Pull
Down
Green Indicator
Pin
Manual/AutomaticModel
Pull
Down
Piercing Pin
Green Indicator
Pin
Manual Model
Green Indicator
Red Spring
Cap In Deflate
Position
Cap In Deflation
Position
Cap In Inflation
Position
Piercing PIn
Pull
Down
Green Indicator
Pin
Manual/AutomaticModel
Pull
Down
Piercing Pin
Green Indicator
Pin
Manual Model
FIGURE 2
FIGURE 4
FIGURE 3
FIGURE 5
Lever In
Up-and-Ready
Position
CO
2
Cylinder
Manual Inflator
Green Indicator Pin
Pull Tab
Lanyard