Nautique 216 Boat User Manual


 
4-33
Controls and Indicators
Switches
Each electrical circuit on your boat is equipped with a control
switch. The switches have an indicator light for easy ON/OFF
identification. All switches are circuit breaker protected.
Refer to Standard Dash Pod in this section for additional
information on switch operation.
Port, Starboard Ballast, 216 Only
These buttons fill and drain the ballast tank designated to the
switch. Ballast tanks are an option on most Nautique boats. A full
description of how these buttons function is discussed in Section 4,
Ballast Tank Control Switches.
Underwater Lights
This switch controls the transom underwater lights. DO NOT
operate lights while the boat is out of the water.
Heater Fan (if equipped)
The heater button controls four different heater functions.
Pressing and releasing the “heater” button turns on Low Speed.
Press again for Medium Speed.
Press again for High Speed.
Press again for Off.
The indicator light for this button will illuminate if the heater is
running at any of the three speeds.
Courtesy/Docking Lights
Press and release for courtesy lights. Press and hold from this
position to turn docking lights on with courtesy lights. To turn the
courtesy lights and the docking lights OFF, press and release.
Docking lights only: from the off position, press and hold until the
docking lights are on and release; to turn off, press and release.
D-Drive Sec 4_2010:Nautique Ski Sec 4.qxd 7/23/09 4:38 PM Page 33