Filter
Top Products
8-5
Care and Maintenance
Cartridge Replacement
1. Turn off power to the bilge pump.
2. Unscrew the filter bowl (A) by
turning counterclockwise and pour
any excess bilge water remaining in
the bowl back into the bilge.
3. Remove the used cartridge (B) and
dispose of in a suitable container.
4. Inspect the O-ring (C) located on
top of the bowl and replace if worn.
5. Be sure that the seals located on the
top and bottom of new cartridge are
in place and correctly aligned.
6. Place the new cartridge into the
bowl and reattach the bowl to the
filter housing (D) by turning
clockwise.
7. Turn on power to the bilge pump.
8. Turn on the bilge pump and inspect all connections for leaks.
9. Bleed any air trapped in the housing by using the bleed button
(F) or, if so equipped, the bleed screw (E). Both are located on
top of the filter housing.
CORC0241
A
B
D
F
E
C
D-Drive Sec 8_2010:Nautique Ski Sec 8.qxd 7/28/09 9:13 AM Page 8-5