Filter
Top Products
4-25
Controls and Indicators
When there are no alarm conditions, the water depth is displayed.
If the signal is weak or lost, or there is no transducer connected, the
display will alternate between the last known depth and four
horizontal bars.
Canceling Depth Alarms
A depth alarm warning can be temporarily canceled by pressing
both s and t on the speedometer, simultaneously. After one
minute, the alarm will resume if the condition that caused the
alarm is not corrected. The operator can cancel the alarm as many
times as necessary, until the condition is corrected.
The depth alarm warning will replace any information on the LCD
screen. Canceling the alarm will restore the LCD to the original
display. If not already in the depth mode, this would be a good time
to switch to it (using M) in order to monitor water depth.
Depth Sounder Alarm Settings
NOTICE
The speedometer display must be in the depth display mode to
change settings. Use the M to scroll to the depth display.
To change the depth sounder alarm settings M must be held down
until the depth display changes to the alarm settings mode.
There are four menus in the alarm settings mode. Pressing and
releasing the mode switch quickly will cycle through the different
options.
Depth Display
CORC121
D-Drive Sec 4_2010:Nautique Ski Sec 4.qxd 7/23/09 4:38 PM Page 25