Filter
Top Products
2.0 GENERAL INFORMATION
Thank you for your purchase of this Patton Electronics product.
This product has been thoroughly inspected and tested and is warrant-
ed for One Year parts and labor. If any questions arise during installa-
tion or use of the unit, contact Patton Electronics Technical Services at
(301) 975-1007.
2.1 FEATURES
• Terminates E1/FE1 Circuits over a 4-Wire RJ-48C interface
• Connects to standard CPE Serial Interfaces
• Common Framed nx64 rates up to 1.984 Mbps
• Unstructured Rate of 2.048 Mbps
• G.703 or G.704 Framing (with or without CRC-4, CAS multi-
frame)
• Selectable AMI or HDB3 Line Coding
• Configuration via Control Port or Internal DIP Switches
• Seven Easy-to-Read LED Indicators Monitor Data & Diagnostics
• Internal, External or Receive Recover Clocking
• Also Operates as a High-Speed Point-to-Point Modem
• Compact Size Plugs Directly into a Router, Switch or other DTE
• Made in USA
2.2 GENERAL PRODUCT DESCRIPTION
The Patton Model 2094 V.35 to E1/Fractional E1 Converter connects
equipment with standard ITU-T V.35 Interfaces to 2.048 Mbps G.703
E1 (clear channel) and fractional E1 G.704 (n x 64) 4-wire 120 ohm
interfaces. Housed in our MicroPak enclosure measuring only 9x 5.3 x
2 cm (3.55 x 2.1 x 0.78 in.) the Model 2094 plugs directly into the V.35
DTE interface of a router, switch, FRAD, multiplexer or other network-
ing device.
The Model 2094 supports all necessary G.703/G.704 diagnostics, DTE
local/remote loops, and V.54 loop up/loop down. Diagnostics are initi-
ated via the Model 2094's control port, or through the DTE or line inter-
faces. Easily readable LED indicators include TD, RD, Loss of Sync
(LOS), Alarm, Error, Test and Power. Configuration of the Model 2094
is done through the control port or using DIP switches.
The Model 2094 presents a RJ48C 120 ohm interface to the line and a
V.35 interface to the customer's device using a Male M/34 connector.
An M/34 to DB-60 adapter cable is available for convenient connection
to Cisco routers. The Model 2094 is powered by an external Universal
Input 100-240VAC adapter.
5
2.3 SUPPORTED APPLICATIONS
The Model 2094 provides an E1 network termination between E1
and Fractional E1 equipment and customer premises equipment (CPE)
such as a router. The Model 2094 can also be used as a high-speed
short haul modem for campus applications.
2.3.1 The 2094 as the Interface between the Telco and CPE
The Model 2094 provides the interface between an E1/Fractional
E1 multiplexer and a router or switch (See below).
2.3.2 The 2094 as a High-Speed Short Range Modem
The Model 2094 can also be installed into high-speed campus
applications. In this application, a pair of Model 2094 units operate as
short range modems (See below).
6
Model 2094
Model 2094