Filter
Top Products
C656M-E (4/07) 17
8. Check the wiring to the controller. Refer to the Spectra Mini dome documentation and the
documentation supplied with your controller to make sure the wiring is correct.
9. Refer to the installation manual for the Spectra Mini dome to complete the installation.
10. Apply power to the system. The following message appears on the monitor as soon as the Spectra
Mini dome configuration cycle is completed:
TXB-V REV x.xx
NOTE: x.xx represents the current firmware revision.
Vicon Controller
Terminal Block J1
Spectra Mini Dome
RJ45-10 Connector
Pin 9 Response Out + Pin 6 (TX+)
Pin 8 Response Out - Pin 5 (TX-)
Pin 3 Command In + Pin 4 (RX+)
Pin 2 Command In - Pin 3 (RX-)