Filter
Top Products
3 – QLA2342/2342L
FCode
3-14 FC2354601-00 A
3.4.3
Setting the QLA2342/2342L HBA Loop ID
When the QLA2342/2342L HBA is currently operating in loop mode (through
connection mode 0 or connection mode 2), perform the following steps to view its
loop ID and change it if necessary:
1. Select the QLA2342/2342L HBA attached to the Fibre Channel device from
which you want to boot. For example, type the following at the ok prompt:
ok " /pci@1f,0/pci@1/QLGC,qla@4" select-dev
2. To view the loop ID, type the show-adapter-loopid command.
ok show-adapter-loopid
The loop ID displays. For example:
Adapter loopid - 7c
3. If the loop ID is not correct, change it using the set-adapter-loopid
command. For example:
ok 0 set-adapter-loopid
The new loop ID displays. For example:
Adapter loopid - 0
3.4.4
Setting and Viewing the Fibre Channel Data Rate
Use the show-data-rate command to view the current QLA2342/2342L Fibre
Channel data rate. For example:
1. Select the QLA2342/2342L HBA attached to the Fibre Channel device from
which you want to boot. For example, type the following at the ok prompt:
ok " /pci@1f,0/pci@1/QLGC,qla@4" select-dev
2. Type the following:
ok show-data-rate
3. The current data rate displays. For example:
Current HBA data rate: One Gigabit rate