Sony PCS-1P Marine Radio User Manual


 
3-6
PCS-1/1P
PPPoE DNS: Obtain automatically
Primary DNS: Cannot be set.
Secondary DNS: Cannot be set.
2. Confirm that the IP address is displayed in the launcher menu of teleconference terminal B.
(Example: IP:192.100.20.20)
3. The LAN setup menu of teleconference terminal A is set as described below.
DHCP Mode: ON
Host Name: Enter any name.
IP Address: Blank
Network Mask: Blank
Gateway Address: Blank
DNS Address: Blank
Gatekeeper Mode: OFF
Gatekeeper Address: Blank
User Alias: Blank
User Number: Blank
SNMP Mode: OFF
Trap Destination: Blank
Community: public
Description: Videoconference Device
Location: Blank
Contact: Blank
NAT Mode: OFF
NAT Address: Blank
Packet Resend Request: Blank
Adaptive Rate Control: OFF (Set to ON when a packet loss occurs frequently.)
LAN Mode: Auto Nagotiation (This mode is changed to a proper mode when mismatching
occurs in the mode. Refer to 4-2. PCS-1/1P and Hub setting.)
Port Number Used: Default (Set to Custom when a port number is specified by the network
administrator.)
TCP Port Number: 2253 (Enter the port number specified by the network administrator when
the port number used is set to Custom.)
UDP Port Number: 49152 (Enter the port number specified by the network administrator when
the port number used is set to Custom.)
TOS: OFF
PPPoE: OFF
PPPoE User Name: Blank
PPPoE Password: Blank
Fixed IP for PPPoE: OFF
Fixed IP Address for PPPoE: Blank
PPPoE DNS: Obtain automatically
Primary DNS: Cannot be set.
Secondary DNS: Cannot be set.
4. Confirm that the IP address is displayed in the launcher menu of teleconference terminal A.
(Example: IP:192.100.10.10)
5. Enter LAN in the phone book of teleconference terminal A for a line I/F, the IP address of
teleconference terminal B in it for an IP address, and other required items. After that, register
teleconference terminal B in the phone book and initiate a call. Or set LAN for a line I/F and the IP
address of teleconference terminal B for an IP address by Dial, and then initiate a call.