Filter
Top Products
3-14
PCS-1/1P
Primary DNS: Cannot be set.
Secondary DNS: Cannot be set.
2. Confirm that the IP address displayed in the launcher menu of teleconference terminal B is
211.10.10.10.
3. The LAN setup menu of teleconference terminal A is set as described below.
DHCP Mode: OFF
Host Name: Blank
IP Address: Blank
Network Mask: Blank
Gateway Address: Blank
DNS Address: Blank
Gatekeeper Mode: OFF
Gatekeeper Address: Blank
User Alias: Blank
User Number: Blank
SNMP Mode: OFF
Trap Destination: Blank
Community: public
Description: Videoconference Device
Location: Blank
Contact: Blank
NAT Mode: OFF
NAT Address: Blank
Packet Resend Request: ON
Adaptive Rate Control: ON
LAN Mode: Auto Nagotiation (This mode is changed to a proper mode when mismatching
occurs in the mode. Refer to “4-2. PCS-1/1P and Hub setting”.)
Port Number Used: Default
TCP Port Number: 2253
UDP Port Number: 49152
TOS: OFF
PPPoE: ON
PPPoE User Name: User (account) name acquired from a provider
PPPoE Password: Password acquired from a provider
Fixed IP for PPPoE: On (When fixed IP is acquired)
Fixed IP Address for PPPoE: 210.10.10.10
PPPoE DNS: Obtain automatically (Acquired from a provider. Select “Set” when the
fixed DNS server address is specified. Enter the addresses specified from a
provider in “Primary DNS” and “Secondary DNS”, respectively.)
Primary DNS: Cannot be set.
Secondary DNS: Cannot be set.
4. Confirm that the IP address displayed in the launcher menu of teleconference terminal A is
210.10.10.10.
5. Enter LAN in the phone book of teleconference terminal A for a line I/F, IP address 211.10.10.10 of
teleconference terminal B in it for an IP address, and other required items. After that, register
teleconference terminal B in the phone book and initiate a call. Or set LAN for a line I/F and IP
address 211.10.10.10 of teleconference terminal B for an IP address by Dial, and then initiate a call.