Filter
Top Products
Page 22 of 38
This screen allows the operator to adjust the convey time
(CONVEY), dump delay (DUMP), and the number of tries
before the no convy alarm activates (NO CONVEY).
To disable a station, set the convey time to 0 (zero).
Important!
DO NOT set the Dump delay or No Convey to 0 (zero).
To set the parameters for each receiver, use the left (◄)
or right (►) arrow keys to scroll through the settings for
the next (►) or previous (◄) receiver.
5-2-1-1-1 Setting Pump Parameters
To access the pump screen, press the right
arrow key (►) when in the station 5 screen or
press the left arrow key (◄) when in the
blowback screen.
This screen allows the operator to adjust the
pump motor ramp up/ramp down time (RAMP)
and the amount of time the pump runs unloaded
before shutting off (IDLE).
Important!
DO NOT set the Idle Time or Ramp time to 0 (Zero).
5-2-1-1-2 Setting Blowback Parameters
Once the pump parameters have been set, the
blowback parameters will need to be configured.
This screen can be accessed for each station,
by pressing the right arrow key (►) when in the
pump parameters screen (RAMP and IDLE
times are displayed).
This screen allows the operator to adjust all
those settings related to cleaning the filter
chamber: the number of conveys before
blowback (CNV>BB), the duration between
blowback pules (BB OFF), the duration of the
pulse (BB ON), and the number of cleaning
pulses (BB CYC).