Sterling SSC1-5Q Marine Battery User Manual


 
Page 29 of 38
8-2 Alarms
The format for all station alarms is “Station n [alarm text],” for
example, “Station 12 receiver low level.” The format for all
pump alarms is “Pump n [alarm text].” Any alarm that does
not start with “Station” or “Pump” is a system alarm.
The following tables list all alarms alphabetically, together
with possible causes. A “critical” alarm is one that causes the
affected device to stop.
Note: You can also see a list of alarms and their causes in the
controller’s online help. To display this information, touch the
color key of statuses in the upper right-hand corner of either
the “Station Status” or the “Pump Status” screen, or touch
Help at any other screen. When you are finished reviewing
the help, touch Return.
8-2-1 Station Alarms
Alarm message Possible cause
Material line is blocked.
Vacuum line is blocked.
Convey time is too long (time-fill station only).
Sequence valve has malfunctioned.
Vacuum switch has malfunctioned.
High vacuum
Note: After you have corrected the cause of this alarm, the alarm will be
cleared when the controller has conveyed a full load to this station.
Material container is empty.
Material line is disconnected from material source.
Vacuum line is disconnected from station.
Take-off compartment is not adjusted properly.
Convey time is too short.
No convey
Note: As a stopgap measure, you can disable the “no convey” alarm for
this station until the problem can be remedied.
8-2-2 Pump Alarms
Alarm message Possible cause
Circuit breaker or overload protector has tripped.
Pump failure
(Critical)
Contactor has malfunctioned.