Topcon GPT-2006 Marine Instruments User Manual


 
8 LAYOUT
8-4
8.1.2 Selecting Coordinate Data File
You can execute a Layout from selected coordinate data le, also you can record New point measured
data into the selected coordinate data le.
The only coordinate data le existing can be selected and you can not make a new le in this mode.
For more information about File, refer to Chapter 9 “MEMORY MANAGER MODE”.
When LAYOUT MODE is begun, a le can be selected in the same way.
Operating procedure Operation Display
1 Press the [F1](SELECT A FILE) key from the
Layout menu 2/2.
[F1]
2 Press the [F2](LIST) key to display the list of
coordinate data le.*1)
[F2]
3 Scroll le list by pressing the [ ]or[ ] key and
select a le to use. *2),3)
[ ]or[ ]
4 Press the [F4](ENTER) key.
The le will be set .
[F4]
*1) If you want to input le name directly, press the [F1](INPUT) key and enter a le name.
*2) When a le has been selected already, ‘*’ mark is indicated on left of current le name.
For the le discrimination mark (*, @, &), refer to Section 9.3 “FILE MAINTENANCE”.
*3) Data in a le shown with arrow can be searched by pressing the [F2](SRCH) key.
LAYOUT 2/2
F1:SELECT A FILE
F2:NEW POINT
F3:GRID FACTOR P
SELECT A FILE
FN:
INPUT LIST ––– ENTER
COORDDATA /C0123
*TOKBDATA /C0345
TOPCDATA /C0789
––– SRCH ––– ENTER
*TOKBDATA /C0345
TOPCDATA /C0789
SATIDATA /C0456
––– SRCH ––– ENTER
LAYOUT 2/2
F1:SELECT A FILE
F2:NEW POINT
F3:GRID FACTOR P