Filter
Top Products
FL INVERTER AND 15” LCD REMOVAL
FIELD REPLACEABLE UNIT DOCUMENTATION
Satellite
TM
5100 Series
TOSHIBA
Tough Enough for Today’s World
15” DISPLAY MASK REMOVAL
1. Remove two mask seals at the bottom corners of the
display assembly using a pair of fine-tipped tweezers.
2. Remove two M2.5x6 flat head brack screws securing
the display mask.
3. There are 22 latches securing the display mask.
Carefully insert your fingers between the mask and the
LCD panel and pry open the latches starting from the
bottom six latches, to the five latches on the right
and left sides, ending with the six toplatches.
Latch
Mask seals
Display
mask
LCD
LCD module
M2x5 silver screw
FL inverter board
M2x5
brass
screws
M2x5
brass
screws
Mask
seals
Mask
seals
LCD/FL cable
FL cable
1. Remove one M2x5 silver screw securing the
FL inverter board.
2. Carefully lift up the FL inverter board and
disconnect the LCD/FL cable from CN1 and the
FL cable from CN2.
3. Remove four mask seals to expose four screws
securing the LCD module assembly.
4. Remove four M2X5 silver screws securing the
LCD module.
5. Carefully rotate out the top of the LCD module
enough to access the display cable
6. Peel off the tape securing the LCD/FL cable and
disconnect the cable.