Filter
Top Products
User’s Manual 7-4
HW Setup
CPU
This function allows you to set the processor's operating mode.
Dynamic CPU Frequency Mode
This option allows you to configure the power saving modes associated
with the processor - the following settings are available:
LAN
Wake-up on LAN
This feature lets the computer's power be turned on from shudown when it
receives a wake-up packet (Magic packet) from the LAN.
Power will be automatically turned on when a signal is received from an
administrator's computer which is connected via a network.
The following settings can be changed when the Built-in LAN is Enabled.
Connect the AC adaptor when using the Wake-up on LAN function. The
battery retention time will be shorter than the times listed in this manual
when this function is enabled. Refer to the section in chapter 6, Battery
exhausted time.
Enabled Enables the Wake-up on Keyboard function.
Disabled Disables the Wake-up on Keyboard function (Default).
Dynamically
Switchable
The processor's automatic clock speed switching
function is enabled - in use the processor's
operation is automatically switched when
necessary (default).
Always High The processor's automatic clock speed switching
function is disabled - in use the processor will
always run at its highest level of power
consumption and its highest speed.
Always Low The processor's automatic clock speed switching
function is disabled - in use the processor will
always run at a lower level of power consumption
and a low speed.
Do not install or remove a memory module while Wake-up on LAN is
enabled.
■ The Wake-up on LAN function consumes power even when the system
is off. Leave the AC adaptor connected while using this feature.
■ Regarding Wake-up on LAN from sleep or hibernation, you must check
the "Allow the device to wake the computer" check box within the LAN
Device properties. (This feature does not effect the Wake-up on LAN
from sleep or hibernation.)