Filter
Top Products
User’s Manual E-2
TOSHIBA PC Health Monitor
The TOSHIBA PC Health Monitor software does not extend or modify
Toshiba's obligations under its standard limited warranty in any way.
Toshiba's standard limited warranty terms and limitations apply.
Starting the TOSHIBA PC Health Monitor
The TOSHIBA PC Health Monitor can be started using the following
methods:
■ Click Start -> All Programs -> TOSHIBA -> Utilities -> PC Health
Monitor.
■ Click the icon ( ) in the notification area, then click the "Enable PC
Health Monitor..." message the first time you run the application
and "Run PC Health Monitor..." every time thereafter.
No matter which method is used, the TOSHIBA PC Health Monitor
explanation screen will be displayed.
Clicking Next will display the PC Health Monitor Software Notice
& Acceptance screen. Please carefully read the information displayed.
Selecting ACCEPT and clicking OK will enable the program. By enabling
the TOSHIBA PC Health Monitor software, you agree with these terms and
conditions and to the use and sharing of the collected information. Once
the program is enabled, the TOSHIBA PC Health Monitor screen is
displayed, and the program will begin monitoring system functions and
collecting information.
If a TOSHIBA PC Health Monitor message is displayed
A message will be displayed if any changes which may interfere with the
operation of the program are detected.
* If a message is displayed, follow the instructions displayed on screen.
Cleaning the cooling module
This section explains how to clean the cooling module.
To clean the cooling module, follow the steps detailed below:
1. Shut down the computer - make sure the Power indicator is off (refer to
the Turning off the power section in Chapter 1, Getting Started if
required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Close the display panel and turn the computer upside down.
If you use the computer for a long period, the inside of the computer may
become hot. Always allow the computer to cool to room temperature
before you clean the cooling module.