Filter
Top Products
User’s Manual 8-9
Troubleshooting
BD Combo Drive
For more information, refer to Chapter 4, Operating Basics.
Some CD/DVDs run
correctly, but others do
not
The software or hardware configuration may be
causing a problem. Make sure the hardware
configuration matches your software’s needs.
Check the CD/DVD’s documentation.
Check the type of CD/DVD you are using. Refer
to Chapter 3, Hardware, Utilities and Options for
more information.
Check the region code on the DVD. It must
match that on the drive. Region codes are listed
in the Optical Disc Drive section in Chapter 2,
The Grand Tour.
Cannot write correctly If you have trouble writing, make sure you are
observing the following precautions:
■
Use only media recommended by TOSHIBA
■ Do not use the mouse or keyboard during writing.
■ Use only the software supplied with the computer
for recording.
■ Do not run or start other software during writing.
■ Do not jar the computer during writing.
■ Do not connect/disconnect external devices or
install/remove internal cards during writing.
If problems persist, contact your dealer.
Problem Procedure
Problem Procedure
You cannot access a
CD/DVD/BD in the
drive
Make sure the drive’s drawer is securely closed.
Press gently until it clicks into place.
Open the drawer and make sure the CD/DVD/BD
is properly seated. It should lie flat with the label
facing up.
A foreign object in the drawer could block laser
light from reading the CD, DVD, or BD. Make
sure there is no obstruction. Remove any foreign
object.