Filter
Top Products
E-8 Uniden MHS135DSC Radio Owner’s Manual
until your transmission is nished and then checks the channels.
If you activate DSC Watch while operating in
Normal mode, the radio checks channel 70
every few seconds.
Scan
You can save channels into memory and then use scan mode to monitor those channels
from lowest to highest. If the radio detects a signal on a channel, it stays on that channel
as long as the signal is received; when the signal stops, the radio continues scanning.
x To activate scan mode, press and hold CLR/SCAN.
x You must have at least two channels in memory to start a scan.
x You cannot transmit while in scan mode.
x To save a channel into memory, select the channel, then press and hold the
GPS/
MEM button. The MEM icon displays whenever you tune to that channel.
x To remove a channel from memory, set the radio to that channel, then press and
hold the
GPS/MEM button. The MEM icon no longer displays.
x When the radio stays on a channel, press
Channel Up to leave that channel and
resume scanning.
x To end the scan, press and hold the
CLR/SCAN button again; the radio remains on
the last scanned channel.
If you activate Weather Alert Watch while in scan mode, the radio checks the most
recently-used weather channel every few seconds, then continues scanning the next
channel in memory:
If you activate Triple Watch while operating in scan mode, the radio checks channels 16
and 9 every few seconds, then goes on to scan the next channel; with Dual Watch
70
Every few seconds, the radio
checks channel 70
with DSC Watch on
70
70
Monitoring Channel 25
11
1008 1312
14
17
15
The radio scans about
5 channels in 0.5 seconds.
When it detects a signal, the radio stays
on the channel until you press the
Channel Up button or the signal stops.
Resume
scan
Every few seconds, the radio
checks the last-used weather
channel, then scans the next
channel.
wx
WX Alert
Watch on
Memory Channel Scan
08 252417151413121110 20