E-11Uniden MHS135DSC Radio Owner’s Manual
4. Insert the two hooks on the lower part of the case into the notches on the cover;
close the cover. (The cover ts snugly but you should not have to force it closed.)
5. Install the alkaline battery case in your radio just as you do the Li-Ion battery (see
page E-10).
You can mount the charger on any at surface.
1. Use the two holes at the base of the charger as a template to mark the drill holes.
2. Using a 1/8-inch (or 3 mm) drill bit, drill two holes 1/2 inch (13mm) deep.
3. Use the provided screws to attach the charger to the surface.
Your radio includes a charger and a rechargeable battery pack.
Place your radio in the charger with the display facing forward.
Make sure that the CHARGE LED on the charger turns orange.
x Use only the battery and charger supplied with this radio. Using a different
charger or battery can damage the radio and create a risk of re or shock.
x The charger is not waterproof. If the charger falls into the water, unplug it
before attempting to remove it from the water. After you remove the charger
from the water, please contact Customer Service (see the back cover page
for contact information).
x Wipe off dirt or shake water from your radio before placing in the charger if
your radio gets dirty or wet.
Important notes on charging the baery
x Charge the battery fully before using the radio.
x Don’t use the charger when the ambient temperature is below 0° C (32° F) or
above 45° C (113° F).
x If the radio is powered down, the battery can charge in about seven hours. (If the
radio is powered on, the battery takes longer to charge.)
Press the POWER button for at least two seconds to turn the radio on. Press and hold it
to turn the unit off.