Filter
Top Products
Transmitting
The UH-100 transmits on 40 UHF CB channels. For your reference, a listing of all the
available channels is printed on the back cover.
1. Select the desired channel.
ego CH01
UEU
,-,
LI
,
I
s
I{ 76.1{t?5MHz
2. To transmit, press the PTT switch to activate the transmitter.
-
.
'116.'1('5....
..
m MEAl
RF 1
I{ 76.1{t?5MHz
,-,
LI
,
I
<e> (!D <aDS
TSQ
Note: Hold the microphone 2-4 inches from your mouth and slightly to one side so that
your voice does not project directly into the microphone. Speak at a normal
voice level. Never raise your voice or shout into the microphone.
3. Release the PTT Switch, to end the transmission and listen for the reply.
Mal
,-,
LI
,
I
s
I{ 76.1{t?5MHz
Using Repeater Channels
UHF CB Repeaters are used to retransmit or relay your signal. Repeaters will extend
the range of your radio and overcome the shielding effect caused by solid obstructions.
In normal Simplex operation, your radio transmits on one particular frequency and
receives on that same frequency. If there is a barrier (Le. valley) that partially blocks
your transmitted signal, the probability of another radio receiving the signal is very
slim. Valleys, tall buildings, metallic structures, ... etc. tend to act as a screen between
radios.
Standard Operation without
the aid of a repeater Station
""""'-..
Normal Simplexoperat~
Transmitting on CH 01 '\
\ '
No si~nal being
Received
10