Filter
Top Products
2. Group Scan (GS) Mode
Allows youto monitor a Priority Channel while scanning.
To use GS Mode Scanning, press the OS I GS key.
GS icon appears on the display. OS Mode is indicated
by the absence of the GS icon.
GS Scanning checks the Priority channel activity
regularly.
If the Priority channel becomes active the radio will stay
on that channel for as long as the signal is present. If
the received signal ceases, Priority scanning continues
after 3 seconds.
If scanning stops on a channel which is not a Priority
Channel, UH-100 will continue monitoring the Priority
Channel for activity while listening to the active one.
egoCH40 becomes active.
MEMGS ,'<E71,-,
SCN0'" ,=
-=,-,
~
MEM
GS
SCN
PRI
, -,
, ,
MEM
I
as
S SCN
I{ 75.825MHzPRI
, -,
, ,
MEM as , , ,-,
S 1SCN "'
" ,
1{711{OOMHz -
~
MEM
as
S SCN
I{ 75.825MHzPRI
, -,
, ,
To deactivate SCAN, press the SCN key or the PTT Switch.
Note: If SCAN is deactivated whileitis tuned at an active channel, the UH-100will
stay on that active channel. If none of the channels are active, the
UH-100willreinstate the Prioritychannel.
If GS Scanning is initiated when there are no channels programmed in GS
memory, an error tone will be heard and scanning will not start.
14