11
Mounting the inverter
Before mounting the inverter, please see “Choosing a location”.
To mount the inverter:
1. Make sure the ON/OFF switch is in the OFF position.
2. Select an appropriate mounting location and orientation. The
inverter must be oriented in one of the following ways:
• Horizontally on a vertical surface. (Do not mount with the fan
pointing up or down.)
• On or under a horizontal surface
3. Hold the inverter against the mounting surface, mark the positions
of the mounting screws, and then remove the inverter.
4. Pilot drill the four mounting holes.
5. Fasten the inverter to the mounting surface using corrosion-
resistant #8 screws.
XPower450.book Page 11 Tuesday, September 7, 2010 12:39 PM