Filter
Top Products
975-0527-01-01 27
Installing the Inverter/Charger
This guide for use by qualified installers only.
7. Before proceeding, check that the cable polarity is correct: POSITIVE
(+) on the inverter/charger is connected to the POSITIVE (+) on the
battery, and NEGATIVE (–) cable is connected to the NEGATIVE (–)
terminal on the inverter/charger.
8. Connect the other end of the cable to the NEGATIVE (–) terminal on
the battery.
9. Use a wrench to tighten the nut to a torque of 10–11 ft-lbs (13.6–
14.9 Nm)
at the inverter/charger end.
10. To protect the DC terminals, attach the DC terminal covers (Figure 4)
to the inverter/charger, using the screws provided.
Figure 3
DC Cable Connections
IMPORTANT:
The next step is the last cable connection you need to make.
A spark is normal when this connection is made.
Figure 4
DC Terminal Covers