Filter
Top Products
Chapter 3 Status Screens
NWA-3500/NWA-3550 User’s Guide
41
System Information
System Name This field displays the NWA system name. It is used for
identification. You can change this in the System > General
screen’s System Name field.
Model This field displays the NWA’s exact model name.
Firmware Version This field displays the current version of the firmware inside the
device. It also shows the date the firmware version was created.
You can change the firmware version by uploading new firmware
in Maintenance > F/W Upload.
System Up Time This field displays the elapsed time since the NWA was turned on.
Current Date Time This field displays the date and time configured on the NWA. You
can change this in the System > Time Setting screen.
WLAN1 Operating
Mode
This field is not available when the NWA is in AP controller
management mode.
This field displays the current operating mode of the first wireless
module (AP, Bridge / Repeater, AP + Bridge or MBSSID). You
can change the operating mode in the Wireless > Wireless
screen.
WLAN2 Operating
Mode
This field is not available when the NWA is in AP controller
management mode.
This field displays the current operating mode of the second
wireless module (AP, Bridge / Repeater, AP + Bridge or
MBSSID). You can change the operating mode in the Wireless >
Wireless screen.
Management VLAN This field displays the management VLAN ID if VLAN is active, or
Disabled if it is not active. You can enable or disable VLAN, or
change the management VLAN ID, in the VLAN > Wireless
VLAN screen.
Rogue AP
Detection
This field is available only when the NWA is in AP controller
management mode.
This field displays whether rogue AP detection is turned on
(Enable) or not (Disable).
IP This field displays the current IP address of the NWA on the
network.
LAN MAC This displays the MAC (Media Access Control) address of the NWA
on the LAN. Every network device has a unique MAC address
which identifies it across the network. Your NWA features dual
wireless module, and has two MAC addresses. The MAC address of
the first wireless module (WLAN1) is used on the LAN.
WLAN1 MAC This field is not available when the NWA is in AP controller
management mode.
This displays the MAC address of the first wireless module.
WLAN2 MAC This field is not available when the NWA is in AP controller
management mode.
This displays the MAC address of the second wireless module.
Table 4 The Status Screen
LABEL DESCRIPTION