4-16
Chapter 4: BIOS Setup
First Boot Device [Floppy]
This field sets the priority of the first boot device. By default, the system
boots up on the floppy diskette drive. Configuration options: [Floppy]
[LS120] [HDD-0] [SCSI] [CDROM] [HDD-1] [HDD-2] [HDD-3] [ZIP] [USB-
FDD] [USB-ZIP] [USB-CDROM] [USB-HDD] [LAN] [Disabled]
Second Boot Device [HDD]
This field sets the priority of the second boot device. By default, the
system boots up on the hard disk driver if the floppy drive is not present.
Configuration options: [Floppy] [LS120] [HDD-0] [SCSI] [CDROM] [HDD-1]
[HDD-2] [HDD-3] [ZIP] [USB-FDD] [USB-ZIP] [USB-CDROM] [USB-HDD]
[LAN] [Disabled]
Third Boot Device [CDROM]
This field sets the priority of the third boot device. By default, the system
boots up on the LS120 if the floppy and hard disk drive are not present.
Configuration options: [Floppy] [LS120] [HDD-0] [SCSI] [CDROM] [HDD-1]
[HDD-2] [HDD-3] [ZIP] [USB-FDD] [USB-ZIP] [USB-CDROM] [USB-HDD]
[LAN] [Disabled]
Boot Other Device [Enabled]
By default, this field allows you to boot from other devices, aside from the
first three priority devices. Configuration options: [Enabled] [Disabled]
Boot Up Floppy Seek [Enabled]
If enabled, this field speeds up the Power On Self Test (POST) routine by
skipping and retesting a second, third and fourth time.
Configuration options: [Enabled] [Disabled]
Boot Up NumLock Status [On]
This field sets the capability of the NumLock light/key to display/activate
the system. Configuration options: [On] [Off]
Gate A20 Option [Fast]
This field sets the gate A20 rate. The default is [Fast].
Configuration options: [Normal] [Fast]