Filter
Top Products
Line Assignment
Hotline and doorphone exten-
sions should not have outside
lines assigned to them, to
prevent calls from being made or
received on them.
Assigning lines to particular line
buttons is useful for grouping
similar lines (such as inbound
and outbound WATS lines) on
adjacent line buttons (such as D
and H).
Assign only as many lines to an
extension as that extension can
use. For example, a PARTNER
6-button phone can have only
four outside lines.
Code:
#301
Description:
Use this procedure to change the line assignments on specific
extensions. These changes include adding lines, deleting lines, and setting the
order of the lines on a PARTNER phone’s line buttons.
Valid Entries: ✓ 1 = Assigned
2 = Not assigned
Considerations:
Use this procedure to fine tune the number of lines assigned to
all extensions through procedure #104, Number of Lines. For example, if you
used procedure #104 to assign 5 lines to all extensions and there are 8 lines in
the system, use procedure #301 to assign lines 6, 7, and 8 to specific exten-
sions.
Programming Notes:
When you use procedure #301 to assign a line to an
extension with a PARTNER phone, the line goes to the first unused line button on
the phone. The order in which line buttons are assigned appears at the left. For
example, if the extension has no lines assigned to it and you assign
line 4 first, that line is put on line button A. If the extension had two other lines
assigned to it, line
4
would be put on line button C.
To change the order of existing line assignments, first unassign the lines and
then reassign them in the desired order.
Programming Steps:
1.
Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 3 ] [ 0 ] [ 1 ]. The
display reads:
LineAssign
Extension:
2. Enter the extension number to be programmed (10 through 33). For
example, to program extension 15, press [ 1 ] [ 5 ] . The display reads:
LineAssign 15
Line:
3. Enter the line to be assigned or unassigned. For example, to select line 1,
press [ 1 ] . The display reads:
LineAssign 15 L1
1 Assigned
If you don’t want an extension to have the line, press [ Next Data ]. The
display reads:
LineAssign 15 L1
2 Not Assigned
To program another line for this extension, press [ Next Item ]
or
[ Prev Item ] until the correct
line number shows on the display. Repeat step
3.
Label the line assignments on each PARTNER phone.
To program another extension, press [ Next Proc ] [ Prev Proc ] and begin at
step 2.
3-12 System Programming