Filter
Top Products
Doorphone
Code: #606
Alert
Description:
Identifies the extension or extensions that ring when someone
Extensions
presses the button on a doorphone. Each doorphone can have up to five alert
extensions. The doorphones can have five individual alert extensions or they
can share alert extensions. Use procedures #604 and #605 (Doorphone 1 and
Doorphone 2 Extensions) to assign doorphone extensions.
Valid Entries:
✓
1
= Not an alert extension
2 = Doorphone 1 alert extension
3 = Doorphone 2 alert extension
4 = Both doors alert extension
Programming Steps:
1.
Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 6 ] [ 0 ] [ 6 ]. The
display reads:
DoorPhneAlert
Extension:
2. Enter the first alert extension. For example, to select extension 10, press
[ 1 ] [ 0 ]. The display reads:
DoorPhneAlert 10
1 No Alert
3. To change the alert status, enter the appropriate setting as listed above.
For example, to make this extension an alert for both doorphone exten-
sions, press [ 4 ] . The display reads:
DoorPhneAlert 10
4 Doors 1 and 2
To select another alert extension, press [ Next Item ] or [ Prev Item ] until the extension number
shows on the display. Repeat step 3.
IMPORTANT:
If you press [ Next Proc ] , the system skips procedure #728, Sys-
tem Reset—Programming Saved and returns to procedure #101, System Date.
To use procedure #728 at this point, you must enter [ # ] [ 7 ] [ 2 ] [ 8 ] .
✓
=
Factory Setting
To go to the next procedure: [ Next Proc ] To go to
a
specific procedure: [ # ] [ x ] [ x ] [ x ]
To go to the previous procedure: [ Prev Proc
]
(where XXX is the procedure number)
To return data to the factory setting: [ Remove ]
To exit system programming: [ Feature ] [ 0 ] [ 0 ]
System Programming 3-33