Filter
Top Products
56
English
Product Features
Introduction
Advanced Operation
Scanning of Memory Channels
During Memory Scan mode, the radio rapidly switches from
one recorded channel to another. When any activity is
detected, the radio stops the scan for 10 seconds for brief
listening on that channel. The scan continues until the radio
is switched out of the Memory Scan mode.
NOTE
If there are fewer than two (2) channels recorded, the
Memory Scan mode is not available. (For instructions
on recording at least two channels, see Memory
Channels, page 55.)
NOTE
The radio must be squelched for the Memory Scan
mode to function. See page 38 for Squelch
procedure.
To Enter Memory Scan:
From Standby mode, press the Memory Scan button.
The radio immediately begins to scan the channels selected
and MEM SCAN (memory scan) shows on the LCD.
To Exit Memory Scan:
From Memory Scan mode, press the Memory Scan button.
The radio returns to Standby mode on the last scanned
memory location.
During Memory Scan When Receiving
an Incoming
Transmission:
1. Press the Memory Scan button to remain on that
memory location and end scanning. The radio returns to
Standby mode.
2. Press the Channel Up/Down microphone channel buttons
or turn the Channel knob to resume scanning.
If no button is pressed within 10 seconds, the radio
automatically resumes scanning.
During Memory Scan When Not Receiving
an Incoming
Transmission:
Press the Talk button to communicate on the last active
channel scanned and return to Standby mode.
Operating Your Radio
Memory Scan/
Clear Button
Scanning
Memory Channel
8187-F80-Operation-8_MMB:F75-Operation-8 12/29/06 9:03 AM Page 56